Showcasing our shoe and handbag repairs with before and after photos
Viewing entries in
Boots
The leather on these Red Wing 1178 boots was starting to look a little unhealthy while the soles and heels were heavily worn. We cleaned, conditioned and polished the leather uppers before performing a full resole, replacing the heels and soles with entirely new ones.
The rubber soles on these Blundstone boots had begun to disintegrate, beyond repair. We replaced the soles with a pair of new Vibram rubber soles.
These Chippewa Service boots were built to withstand the most rugged terrains and work, but over years the original rubber soles and heels had worn down, needing replacement. We performed a full resole, replacing the heels and soles with entirely new ones.
These RM Williams Comfort Craftsman boots were stained due to spilled butter. We cleaned the suede and treated it with a stain remover, effectively getting rid of the stain.
These RM Williams Craftsman boots had the toes of the right boot chewed by a family pet and thus heavily damaged. We used a leather filler and some careful leather polishing and recolouring to repair the gouged leather.
The soles and heels on these RM Williams Adelaide boots had worn down and needed replacing. We replaced the heels with new RM Williams rubber heels and performed a half re-sole, adding a new pair of leather half soles.
These Barker Hopper Chelsea boots had leather soles and quarter-rubber heels that were in need of replacement. We perform a full re-sole, replacing the heels and soles along the entire length of each boot with a fresh pair of quarter-rubber heels and single-piece leather soles.
These RM Williams Craftsman boots had been mauled by a puppy, leaving the leather around the toes chewed right off. We repair the mauled leather, smoothing out and then filling the gaps before recolouring / refinishing the leather.
The soles and heels on these Loake Chelsea boots needed replacing. We performed a full re-sole, replacing the original rubber heels and leather soles with a pair of new Dainite soles and heels covering the entire length of each boot.
The heel caps and rubber soles on these RM Williams Comfort Craftsman boots had worn out. We re-heeled the boots with original RM Williams rubber heels and performed a half re-sole using Topy rubber half soles.
